KEY FEATURES:

✔ Custom Controls specified for HH Strat
✔ 6-Way Coil Split Switching System
✔ Pro-grade components
✔ Fits Fender Stratocaster
✔ Fits Squier Stratocaster with adjustments 

SUPER EASY, SOLDER-LESS INSTALL

All Obsidian Pro-Wired Electronics are super easy to install, and allow for solder-less pickup changes with Obsidian Plug, Play & Enjoy connectors.

6 WAY SWITCHING - HUMBUCKERS TO SINGLE COILS

Let the Custom 6 -Way upgrade for HH Strat split your humbuckers into single coils for classic, low output spank, and back again to full output with a tap of the volume control.

SWITCH POSITIONS: PUSH-PULL OFF (DOWN)

1: Bridge Humbucker (Full)
2: Bridge & Neck - Humbucker (Full)
3: Neck  - Humbucker (Full)

SWITCH POSITIONS: PUSH-PULL ON (UP) - REQUIRES 4 CONDUCTOR WIRE PICKUPS

1: Bridge - Single Coil (Split)
2: Bridge & Neck - Single Coil (Split)
3: Neck - Single Coil (Split)

CONTROL LAYOUT 

1: Master Volume
2: Tone Control 1 (Neck)
3: Tone Control 2 (Bridge)

CRYSTAL CLEAR TONE

To make your tone crystal clear at lower volumes we also include an Obsidian Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.

COMPONENTS

Potentiometers: Obsidian Custom CTS Pots 500K (+/-10%) Split Shaft / 24 Spline
Capacitors: 150 Series Polyester Film 0.022uf (+/-5%)
Switch: Genuine Oak 3-Way Switch
Jack: Pro-Wired Switchcraft J11 Mono

COMPATIBILITY 

Fender Stratocasters - Direct Fit 
Squier Stratocasters - Widen Control holes to 10mm & replace knobs with US spec 24 spline knobs

DOES NOT FIT: Left Handed Guitars; Any guitar not described above.