KEY FEATURES:

✔ Custom Controls specified for HSH Strat
✔ 500k for Humbuckers = Clarity & Output
✔ 250k for Single Coil = Warmth & Quack
✔ Fits Fender Stratocaster
✔ Fits Squier Stratocaster with adjustments 

SUPER EASY, SOLDER-LESS INSTALL

All Obsidian Pro-Wired Electronics are super easy to install, and allow for solder-less pickup changes with Obsidian Plug, Play & Enjoy connectors.

OPTIMIZED FOR HUMBUCKER & SINGLECOILS

The Obsidian HSH Wiring Harness for Fender Stratocaster is the perfect way to open up your humbuckers with some extra clarity and output, while retaining that sweet single coil tone.

The trouble with a traditional wiring kit in a Strat with humbuckers and single coils is that humbuckers need a good 500k potentiometer for full clarity and output, while the single coils need a 250k set of tone and volume controls to tame some of their natural highs.

Obsidian is the perfect solution with a special custom design allowing for auto switching between 500k tone and volume controls in the full humbucker positions and 250k controls for the single coil positions.

AUTO SWITCH CONTROLS:

500k for humbuckers (full output & clarity)
250k for single coils (traditional Strat tone)

AUTO SPLIT HUMBUCKERS:

In Positions 2 + 4 (better balance with middle pickup) 

When you move your switch into the mixed pickup positions the humbucker coils split (requires four conductor humbuckers), with one of them pairing up with the middle pickup for traditional Strat tone.

SWITCH POSITIONS AND CONTROL LAYOUT 

1: Bridge Humbucker Full (500k // Tone 2)
2: Bridge Humbucker Split + Middle (250k // Tone 1)
3: Middle (250k // Tone 1)
4: Neck Humbucker Split + Middle (250k // Tone 1)
5: Neck (500k // Tone 2)

NOTE: Coil Splitting Requires Four Conductor Wire Neck and Bridge Pickups

CRYSTAL CLEAR TONE

To make your tone crystal clear at lower volumes we also include an Obsidian Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.

COMPONENTS

Potentiometers: Obsidian Custom CTS Pots (+/-10%) Split Shaft / 24 Spline
Capacitors: 150 Series Polyester Film 0.022uf & 0.047uf (+/-5%)
Switch: Obsidian/Schaller Propriety Switch (Requires Metric Tip)
Jack: Pro-Wired Switchcraft J11 Mono

COMPATIBILITY 

Fender Stratocasters - Direct Fit 
Squier Stratocasters - Widen Control holes to 10mm & replace knobs with US spec 24 spline knobs

DOES NOT FIT: Left Handed Guitars; Any guitar not described above.