KEY FEATURES:

✔ Custom 4-Way Control Layout
✔ Play Pickups in Humbucker Mode (Series) 
✔ Fits Fender Telecaster
✔ Fits Squier Telecaster with adjustments 

SUPER EASY, SOLDER-LESS INSTALL

All Obsidian Pro-Wired Electronics are super easy to install, and allow for solder-less pickup changes with Obsidian Plug, Play & Enjoy connectors.

Custom 4-Way Wiring Harness for Tele

The Obsidian Custom 4-Way wiring harness for Telecaster adds a tasty fourth switch position to make your Tele scream.

Kick your Tele into the fourth position and your old work horse becomes a beast.

The neck and bridge pickups work in series to provide a more powerful humbucker like tone. You can use this position for stronger rhythm and screaming leads.

Your Telecaster will retain all of the traditional switch positions, and the familiar master tone and volume controls. 

Requires Three Wire - Neck Pickup Mod * See Below

SWITCH POSITIONS

1: Neck & Bridge in Series (Humbucking)
2: Neck
3: Neck & Bridge in Parallel (Traditional Tele)
4: Bridge

CRYSTAL CLEAR TONE

To make your tone crystal clear at lower volumes we also include an Obsidian Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.

COMPONENTS

Potentiometers: Obsidian Custom CTS Pots 250K (+/-10%)  Solid Shaft 1/4"
Capacitors: 150 Series Polyester Film 0.022UF (+/-5%)
Switch: Genuine Oak Switch
Jack: Pro-Wired Switchcraft J11 Mono

COMPATIBILITY 

American series Fender Telecasters - Direct Fit 
Mexican series Fender Telecasters - Direct Fit 
Japanese Fender & Squiers - You will need to purchase a genuine Fender USA control plate and new 1/4" knobs

DOES NOT FIT: Thinline Telecaster, G&L ASAT, Other Guitars - We cannot guarantee that these will fit any other guitar.

* NECK PICKUP MOD 

To properly ground your neck pickup you will need to add an additional wire to it. This is an easy mod & Obsidian provides the instructions and wire to do the job but it does require a solder joint. Please allow for this when buying this upgrade.